WACOM rectangle pad came off

**Tekuuei** · September 20th, 2009, 04:47 AM

Hi guys, i'm new to this forum. My Wacom rectangle pad came off from the tablet, can i stick it back with super glue or is there any other solution?

Thanks.

**Arshes Nei** · September 20th, 2009, 05:02 AM

That's called an Overlay. Depending on your version of tablet you can order a new one from Wacom. http://direct.wacom.com/stores/5/Par...sories_C65.cfm If your tablet is an intuos 2 or older you may have to look elsewhere for new surface sheets/overlays.

**Tekuuei** · September 20th, 2009, 05:07 AM

Originally Posted by Arshes Nei

That's called an Overlay. Depending on your version of tablet you can order a new one from Wacom. http://direct.wacom.com/stores/5/Par...sories_C65.cfm If your tablet is an intuos 2 or older you may have to look elsewhere for new surface sheets/overlays.

Thanks Arshes, but is it possible to use an adhesive to stick it back?

**Arshes Nei** · September 20th, 2009, 01:45 PM

Possibly, but I wouldn't advise it in case you much up the sensitivity where you put it. By the way depending on your model and newness of when you purchased the tablet you can probably ask wacom to send you a replacement sheet as it should be covered by the warranty. (About 2 years at least)

If you have an intuos1 or 2 you may as well since it's going to be harder to find the sheets anyways.

**rattsang** · September 20th, 2009, 04:24 PM

this happened to my intous 2 when it was well out of warranty, i stuck it back with pva and that worked fine, it can be removed and replaced as needed with more pva and it wont mark the tablet.