Never retreat. Never surrender.
Level 13 Gladiator: Retiarius
I'm making paper textures for painter X and need to offset it to clean up the seams in the texture. Is there a function like in photoshop to clean up the borders of it so there's no seam in the texture? i dont have cs2 or i would use it ;p i just really need a painter solution to it.
"I must not fear. Fear is the mind-killer. Fear is the little-death that brings total obliteration. I will face my fear. I will permit it to pass over me and through me. And when it has gone past I will turn the inner eye to see its path. Where the fear has gone there will be nothing. Only I will remain."
--- Frank Herbert, Dune - Bene Gesserit Litany Against Fear
Check out my Sketchbook! Critique and Criticism welcomed.
or my Deviantart!
· or check out my: Blog
Registered User
Level 1 Gladiator: Andabatae
rom the Art Materials Palette, select Pattern, then select Define Pattern
then all tools, including cloners, will wrap around the edges automatically.
Never retreat. Never surrender.
Level 13 Gladiator: Retiarius
i'm not having a problem with it wrapping, i'm having a problem with seams in the texture. anyone else know how to get rid of seams through painter?
"I must not fear. Fear is the mind-killer. Fear is the little-death that brings total obliteration. I will face my fear. I will permit it to pass over me and through me. And when it has gone past I will turn the inner eye to see its path. Where the fear has gone there will be nothing. Only I will remain."
--- Frank Herbert, Dune - Bene Gesserit Litany Against Fear
Check out my Sketchbook! Critique and Criticism welcomed.
or my Deviantart!
· or check out my: Blog
Registered User
Level 1 Gladiator: Andabatae
I don't use painter alot... but I assume it has a clone stamp equivalent... or even if you were to take a feathered-edge selection from the middle of your paper texture, and copy it over your edge, with the wraparound turned on, you're automatically taking care of the seams because the parts you copied flow around to the opposite side, yes?
There are currently 1 users browsing this thread. (0 members and 1 guests)
Posting Permissions
Reply With Quote
Bookmarks